For our example, we are configuring a HP 2810-48G switch. These commands should also work with the HP5400zl series. == Network Overview == There are a number of different networks and hosts involved with a traditional Emulab setup. For servers, we will have three machines hosted on a VMWare server: * Boss hosts the web interface, main testbed logic, and database. * Users exports filesystems and acts as a general login machine. * Router routes between the various networks. We also have on the network: * HP 2810 Ethernet Switch Management Interface * Dell Remote Access Card for VMWare server * VMWare management interface * Power Controller (APC7902) * Serial Controller (IBM X330 + Obsolete Cyclades multi-port serial card) == Initial Ports == || Port || Device || || 1 || Uplink to Internet || || 2 || Port for Dell Remote Access Card (DRAC) for the VMWare server (PowerEdge 2950) || || 3 || Trunked port for the VMWare installation on the PowerEdge 2950 || || 4 || APC 7902 Power Controller || || 5 || Serial Controller || || 6-9 || Control Network ports for our testbed nodes || == VLANS == || VLAN || IP Range || Use || || 2002 || Depends (our minibed is behind a NAT on 10.0.23.0/24) || Internet VLAN || || 2003 || 192.168.0.0/22 || Control Network VLAN || || 2004 || 192.168.254.0/24 || Control Hardware VLAN || || 2005 || 192.168.253.0/24 || Users Network || || 2006 || 192.168.252.0/24 || Boss Network || == Diagram == [[Image(Mini DETER Network.png)]] == Switch Configuration == == VMWare Network Setup == For the minibed at ISI, the VMWare ESXi server is on a single trunked port. [[Image(vmware_network.PNG)]]